Floating candles are a fun alternative to traditional table candles. Bobbing along in a bowl of water they seem to defy the notion that water conquers fire. Continue reading
The more a person crafts, the more they realize, there are some things that are just a part of crafting life. While crafting is for the most part a very pleasant experience, there are a few things that strike a chord with those who create. Here are a few things that almost every crafter can probably identify with… starting with the fact that those of us who have used glue guns, can attest that they will indeed burn off one’s finger prints…
Candle making is a fun hobby that allows a crafter almost unlimited creativity. Here are the beginning basics for how to make candles. Continue reading
These ornanments are based on Victorian style Christmas ornaments, but require little more than paper.
You will need:
- Beeswax or another type of wax
- A tall dipping container
- A tall container of cold water
- Washers or bolt nuts
- Double boiler (or two pans)
- Scissors or sharp knife
To begin, cover the area with newspapers as this is one of the messiest forms of candlemaking. Decide how long you want your candles. You will be dipping two at a time, so measure a piece of wicking twice your desired length, then add two inches. Cut the wicking. Tie the washers, bolt nuts or a similar small object to the wick. These will be used to weigh down the wicking and keep it straight during the dipping process.
Beeswax makes the best taper candles, as it adheres to its own layers very well, however, any wax can be used to produce decent result. Heat the wax in a double boiler, or if you don’t have one, make one by placing the wax in a pan that sits on top of a second pan filled with water. Heat the wax until it is melted. It is very flamable, so if it begins to smoke, remove it from the burner immediately.
You don’t want the wax to be too hot for this project or the dipped layers will be too thin to adhere. As soon as the wax is melted completely, remove it from the heat. Pour it into the tall dipping container; the container should be several inches taller than your wicking.
Holding the wick in the center, dip both ends into the wax, almost to the top; just beware your fingers don’t touch the wax. Wait until the wick hardens. Dip the wicking into the hot wax once again, then quickly dip it into the container of cold water. This will immediately harden the wax. When you pull the wicks from the water, run your hand down them to remove excess water, which could cause bubbles in the finished candles. Continue alternating dips in the wax and the cold water, removing excess water each time. Keep your dipping hand steady as possible to ensure straight candles. Keep dipping until the candles reach your desired thickness. Usually about 25 dunks makes a good candle.
Using a sharp knife or a pair of scissors, cut the now wax-covered weights off the bottom of the candles. Once more, dip the candles into the wax, then the water to give them a smooth finish. Drape the candles over a stick or a dowel and leave them to completely harden for a few days. At that point, you can cut the wick in the center. The candles can be made into a lovely gift by bundling several together and tying them with ribbon or raffia.
Copyright © Amber Reifsteck ~ The Woodland Elf